Owner's Manual
Step 1- Decide which MODE to use and set DIP switches according to information in
Section
3.
Step 2- Must remove
or
eject all CDs ou't from radio.
Step
3- Remove radio out from dash,
Step
4-
Plug the 14-pin male connector on
USA
SPEC CAS-H2y cable to radio.
If
a factory
cable has the same identical 14-pin male connector already connected to radio,
unplug the factory cable from radio first.
Step
5-
If
your
setting
of
DIP
switch #2
is
at
OFF
position and also the vehicle has
factory
XM
receiver,
go
to
Step 12 instead
of
Step 6
III
Step
6-
Plug the factory
14-pinmale
connector
to
USA
SPEC 14-pin female connector on
CAS-H2y cable. Refer to Fig.(1) in this manual.
Step 7- Plug the round 8-pin DIN connector on
USA
SPEC CAS-H2y cable
to
adaptor
where is labeled RADIO.
Step 8- If the vehicle has Rear-Seat-Entertainment system, wire ACCessory power with a
relay. [refer to Fig. (2)]
Step 9- Connect your audio source to the
RCA
jacks on adaptor
if
AUX
option is selected
by DIP switch
#1
= ON.
Step10- Plug CB-PA105 cable to adaptor where is labeled iPod.
Step 11- Reinstall radio back to dash only after a successful test is done.
step12- Plug factory 14-pin cable to the 14-pin female connector on USA SPEC
CAS-HXM cable. (refer to Fig.3)
step13- Plug the 14-pin male connector on USA SPEC CAS-HXM cable to the 14-pin
female connector
on
USA SPEC CAS-H2y.
step14- Plug the orange color wire on CAS-HXM to
PA
15-HON2 adaptor where is
labeled
XM.
step 14- Go to Step
7,
8,
9,
and
10.
9