Setup Guide
3) Set “0” as Payload type
4) Set “0” as Timeout
9. LE RX test for BT4.0/BT4.1 for “Q) [LE] RX Test” item
1) Set the number as the channel you need.
2) Set “0” as Timeout
10. Single tone of BT2.0, BT4.0/BT4.1 for “C) Set TX Carrier Frequency ARM” item
1) Set “0” as Carrier
2) Set the number as the channel you need.
3) Set “0” as Mode
4) Set “0” as Modulation type
5) Set “0” as Power table index
11. DUT mode for “c) Enable Device Under Test Mode” item