User Manual

DAX-202 User Manual
Page3
Source DB25 pins
Dolby 7/8 6 / 19
DCI 7/8 7 / 20
DCI 15/16 1 / 14
DCI 9/10 18 / 6
DCI 13/14 15 / 3
BNC
—
Setup
1. Using the chart below, determine where the HI/VI-N AES sources will
come from.
2. Remove the four cover screws holding the DAX box together.
3. Close the PAI R of DIP switches that correspond to your source selec-
tion. See Figure 3.
4. Replace the cover screws.
5. Connect the HI output of the cinema processor to the HI inp ut on the
Phoenix connector.
Assemble the Phoenix Connector Plug as Required:
6. Connect the VI-N and HI outputs to the IR or RF transmitter. If the
system has an unbalanced inp ut, be sure to j ump the “ - ” signa l output
Pin Function Comments
1 VI-N + (Output)
2 VI-N - (Output) Connect to Gnd for unbalanced
3 Gnd
4 HI - (Output) Connect to Gnd for unbalanced
5 HI + (Output)
6 Earth Gnd
7 HI - (Input) Connect to Gnd for unbalanced
8 HI + (Input)
9 HI CTL (Control) Connect to Gnd for AES
10 Gnd