Use and Care Manual

Assembly Instructions
A
Threaded Inserts
Pedestal
READ ALL INSTRUCTIONS BEFORE INSTALLING AND USING THE APPLIANCE
TOOLS AND MATERIALS NEEDED FOR INSTALLATION
You will need a #2 phillip screw driver for assembly. Using a drill with a phillips bit will
speed the assembly process. One (1) 7/16” socket/wrench to install wheels. A 5mm hex
drive to install the handles. Use proper assembly technique, when installing bolts start all
bolts rst and then tighten appropriately. The assistance of a second person is strongly
recommended. You will have to remove the grill contents for assembly.
Do Not Remove The Searing Station.
STEP 1 BASE AND PEDESTAL ASSEMBLY
1. Attach the swivel wheels to base using four (4) 1/4-20 x 3/4” bolts. Insert the axle
through the base and slide on wheels, then use acorn nuts provided to fasten.
2. Assemble the pedestal using the provided six (6) 1/4-20 x 3/4” bolts. The bolts will screw
into the already attached threaded inserts.
3. Attach the pedestal to the base using six (6) 1/4-20 x 3/4” bolts along the bottom.
4. Attach main grill body to assembled pedestal with six (6) 1/4-20 x 3/4” bolts. Screw
bolts along bottom of grill body into the rivet nuts already installed in the pedestal
pieces.
Pedestal and Base Assembly
Wheel Installation
Parts List
Description
Pedestal, Right Side
Pedestal, Left Side
Pedestal, Center
Base
Caster Wheel
Fixed Wheel
1/4-20 Bolt x 3/4”
1/4-20 Nut
1/4-20 Bolt x 1-1/4
Side Handle
Handle Installation
STEP 2 HANDLES ASSEMBLY
1. Attach front lid handle to grill lid using supplied bolts.
2. Attach side handle to main grill body using supplied bolts.
Insure the beauty rings are on the handle.
Flat and Lock
Washer
Note: There are three cushion pads installed between the lid and
the body of the unit are for shipping purposes only. Please remove
them.
-6-