Service manual

2DA/2DB
1-5-6
Section Jam code Description Conditions
Duplex
section
DP
Finisher
61
70
71
72
73
74
75
80
81
83
84
Misfeed in duplex exit
section*
1
No original feed*
1
An original jam in the
original conveying sec-
tion 1*
1
An original size error
jam*
1
An original jam in the
original conveying sec-
tion 2*
1
An original jam in the
original conveying sec-
tion 3*
1
An original jam in the
original switchback sec-
tion*
1
Jam between the finisher
and MFP*
1
Intake jam*
1
Jam during paper con-
veying for batch ejection
1*
1
Jam during paper con-
veying for batch ejection
2*
1
The registration switch (RSW) does not turn on within 1760
ms of the duplex paper conveying switch (DUPPCSW)*
1
turning on.
The registration switch (RSW) does not turn off within 1760
ms of the duplex paper conveying switch (DUPPCSW)*
1
turning off.
During the primary feed of the second original in the single-
sided or double-sided original mode, even if retry operation is
performed five times, primary original feed is not performed.
During the secondary original feed in the single-sided or
double-sided original mode, the DP timing switch (DPTSW)*
1
does not turn off within 6500 ms of the original conveying
motor (OCM)*
1
turning on.
During the secondary original feed in the single-sided or
double-sided original mode, the DP timing switch (DPTSW)*
1
does turn off within 750 ms of the original conveying motor
(OCM)*
1
turning on.
During scanning of the second side or reversing of the origi-
nal for ejection in the double-sided original mode, the DP tim-
ing switch (DPTSW)*
1
does not turn off within 6500 ms of the
original conveying motor (OCM)*
1
turning on.
During scanning of the second side or reversing of the origi-
nal for ejection in the double-sided original mode, the DP tim-
ing switch (DPTSW)*
1
does not turn on within 750 ms of the
original conveying motor (OCM)*
1
turning on.
During the switchback operation of an original in the double-
sided original mode, the original switchback switch (OSBSW)
*
1
does not turn on within 1300 ms of the original conveying
motor (OCM)*
1
turning on.
The paper conveying switch (PCSW)*
1
does not turn on
within 1550 ms of the signal requesting paper ejection is out-
put from the MFP.
During paper intake from the MFP, the paper conveying
switch (PCSW)*
1
does not turn off within 1960 to 3480 ms
(depending on paper size) of paper conveying switch
(PCSW)*
1
turning on.
When ejection a stack of paper, the paper conveying switch
(PCSW)*
1
does not turn on within 1590 ms of the paper con-
veying motor (PCM)*
1
turning on.
When ejection a stack of paper, the paper conveying switch
(PCSW)*
1
does not turn off within 2260 to 3190 ms (varies
depending on the paper size) of the paper conveying motor
(PCM)*
1
turning on.
*1: Optional. *2: Optional for 16 ppm model. Standard for 20 ppm model.