Service manual

2DA/2DB

1-6-11

(6) Detaching and refitting the paper conveying unit

Follow the procedure below to maintenance of the paper feed section.

Procedure

1. Remove the drum unit (see page 1-6-38).

2. Remove the strap from the rear side. Restore

the paper conveying unit. Remove the fitting

projection and pin, and then remove the

stopper from the front side.

3. Open the left cover until it is put horizontally.

4. Push the fitting portions of the fixtures located

on the front and rear and then remove the

fixtures from the left cover.

5. Remove the left cover from the MFP.

Left cover

Strap

Fitting projection

Stopper

Fixture

Left cover

Fixture

Figure 1-6-17

Figure 1-6-18