Service manual

2DA/2DB

1-6-19

(10-4) Adjusting the trailing edge margin of image printing

Make the following adjustment if there is a regular error between the trailing edges of the copy image and original.

Procedure

Yes

Start

Enter maintenance mode.

Enter “034” using the numeric keys.

Press the start key.

Press the interrupt key.

Is the trailing edge

margin correct?

Press the start key

The new setting is stored

Press the stop/clear key to exit

maintenance mode.

End

For output example, increase

the value using the right cursor

key.

Setting range: –4.0 – +10.0

Initial setting: 0.0

Changing the value by 1 moves the

trailing edge by 0.1 mm.

Increasing the setting makes the margin

narrower, and decreasing it makes the

margin wider.

Press the start key.

Select the “ADJ. MGN REAR”

using the up/down cursor keys.

Press the start key

to output a test pattern.

Correct image Output

example

Trailing edge margin

Figure 1-6-34