Service manual

2DA/2DB-1
1-6-21
(10-6) Adjusting the amount of slack in the paper
Make the following adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper is
Z-folded.
Procedure
Original Copy
example 1
Copy
example 2
Figure 1-6-36
Start
Enter maintenance mode.
Enter “051” using the numeric keys.
Yes
Yes
No
No
Press the start key.
Press the interrupt key.
Press the start key
to make a test copy.
Decrease the value using the left cursor key.
The new setting is stored.
Select the items to be adjusted
using the up/down cursor keys.
Is the leading
edge of the image missing
or varying randomly (copy
example 1)?
Is the copy
paper Z-folded (copy
example 2)?
Increase the value using the right cuusor key.
Press the start key.
End
Press the stop/clear key to
exit maintenance mode.
Setting range (Initial setting)
PF1: –50 – +127 (20)
BYPASS: –50 – +127 (0)
PF2: –50 – +127 (0)
PF3: –50 – +127 (–20)
PF4: –50 – +127 (–20)
DUPLEX: –50 – +127 (0)
The greater the value,
the larger the amount of slack;
the smaller the value, the smaller
the amount of slack.
PF1: Drawer
BYPASS: Bypass tray
PF2: Optional first paper feeder (standard for 20 ppm model)
PF3: Optional second paper feeder
PF4: Optional third paper feeder
DUPLEX: Duplex copying (second face)