Service manual

1-3-9

2DA/2DB-1

• Installing the drawer heater (option)

Drawer heater installation requires the following parts:

• Drawer heater (P/N 120 V specifications: 2A727480, 220-240 V specifications: 2A727490)

• Ground plate (P/N 3BG02060)

• Drawer heater mounting plate (P/N 3HW02030)

• One (1) M3 × 6 tap-tight S binding screw (P/N B3023060)

1. Remove the rear cover of the paper feeder.

2. Pull out the drawer.

3. Fit the drawer heater to the hook on the

drawer heater mounting plate.

Mount the heater so that the projection of the

drawer heater mounting plate is inserted into

the hole of the drawer heater.

* After mounting, check that the projection is

securely inserted into the hole and that the

drawer heater does not move forward/

backward or right/left.

4. Fit the ground plate to the drawer heater

mounting plate using the M3 × 6 taptite S

binding screw.

Figure 1-3-9-1

5. Insert the drawer heater mounting plate from

the front side of the machine, pass the drawer

heater wire through the hole on the frame at

the rear side of the machine, and pull the wire

out from the rear side of the machine.

6. Fit the two holes at the rear of the drawer

heater mounting plate to the fitting portions at

the rear side of the machine.

Drawer heater

Projection

Drawer heater

mounting plate

Hook

Ground plate

M3 × 6 taptite

S binding screw

Figure 1-3-9-2

Fitting portion

Drawer heater wire

Drawer heater

mounting plate

Hole

1-3-8-1