Service manual

1-3-25

2DA/2DB

Attach the transfer unit.

9. Insert the transfer unit from the MFP front side and

slide it to the left to install to the ejection part.

10. Place the transfer unit closer to the ejection side and

then secure the front side using the TP bind screw

M3 × 06 and the rear side using the pin.

Release the lever securing fitting.

11. Loosen the screw located at the rear side of the

transfer unit and release the lever securing fitting in

the direction of an arrow, and then retighten the

screw.

Transfer unit

TP bind screw

M3 × 06

Screw

Lever

securing fitting

Figure 1-3-43

Figure 1-3-44