Service manual

1-3-35

2DA/2DB

1-3-10 Installing the fax system (option)

Install the optional Memory module DIMM (32MB).

1.Remove the two connectors of the fax control PCB

assembly.

2. Remove the three screws and remove the mounting

plate and the ground wire.

3. Insert the memory module DIMM at an angle into the

memory slot so that the notch of the memory DIMM

is positioned to the projection of the memory slot on

the fax control PCB assembly. (1)

4. Push the free end of the module down toward the

board. (2)

5. Attach the mounting plate and the ground wire that

have been removed by Procedure 2 with the three

screws to their original positions.

6. Connect the two connectors that have been removed

by Procedure 1.

Screws

Fax control PCB assembly

Mounting plate

Connectors

Ground wire

Memory module DIMM

Notch

Memory module DIMM

Memory slot

Projection

Memory slot

Fax control PCB assembly

Figure 1-3-65

Figure 1-3-66