Service manual

1-3-36

2DA/2DB

Remove the shield cover.

7. Remove the six screws, lift the shield cover and then

remove the cover.

Remove the modular cover.

8. Remove the screw and take off the modular cover.

Attach the fax control PCB assembly.

9. Loosen the screw on the printer board.

10. While taking care that the mounting surface of the

board does not contact the frame section of the rear

cover, insert the U terminal of the ground wire of the

fax control PCB assembly and secure it with the

screw.

Screws

Shield cover

Screw

Modular cover

Fax control PCB assembly

Screw

Ground wire

Frame section

Figure 1-3-67

Figure 1-3-69

Figure 1-3-68