Service manual

1-3-43

2DA/2DB

1-3-11 Installing the scan system (option)

Remove the covers.

1. Remove the six screws (a), lift the shield cover and

then remove the cover.

If the fax system is installed, remove the six screws

(a) and screw (b), lift the shield cover and then

remove the cover.

2. Remove the two screws, and take off the cover.

Install the scanner board.

3. Insert the scanner board into the OPT1 opening of

the shield box and firmly push the CN5 connector on

the scanner board all the way into the YC12

connector on the engine circuit board.

4. Fasten the scanner board onto the shield box cover

using the two screws that have been removed by

Procedure 2.

Screws (a)

Screw (b)

Shield cover

Cover

Screws

OPT1 opening

Connector

YC12

CN5

Scanner board

Screws

Scanner board

Figure 1-3-86

Figure 1-3-87

Figure 1-3-88