User's Manual

GE AccessSmart 313 Last Update July 6, 2005
29
9.1.2 INPUT TEST
9.1.3 OUTPUT TEST
9.1.4 LCD TEST
. The ☞ 5digit shows the input status and “0” indicates that the input port is open circuit and “1” indicates that the
input port is short circuit to ground level.
☞. The first two tests are for the output relays (Door Relay and Alarm Relay) test. You can hear the mechanical
sound of relays and LED will blink. Following two tests are for TTL#1 and TTL#2 output testing. The last
test is for the Internal Buzzer test and you can hear two beep sounds.
☞. The LCD will display all characters on the screen. When the test is done, the LCD will show “Last Update
Press any key”.
GE AccessSmart 313 Last Update July 6, 2005
30
9.1.5 KEYPAD TEST
9.1.6 READER TEST
9.1.7 MEMORY TEST
☞. LCD will display all keys of the unit. Press each key from the keypad one by one, the depressed key will
disappear from the LCD. Note that ENT key is “#” and ESC key is “*” on the LCD.
☞. LCD will display “Scanning…” for reading the cards. Present the card to one of the readers.
☞. When the reader successfully read the card, LCD will display Reader number and 8digit card number on the
LCD.
☞. If the Data Memory has problems, LCD will show the Memory failure message. In this case, contact
manufacturer for technical support.