User's Manual

GE AccessSmart 314 Last Update July 6, 2005
41
9.3.8 DOOR OPEN ALARM TIME SETTING
☞. When the door is not closed after the door open time is over, you may set the delay time to generate Door
Open Alarm. To use this function, you have to install a Door Contact Sensor on the door and setup the alarm
time by Door Contact Sensor. ‘03’ sec. is default time.
00: Alarm if the door is not closed after the door open time (Door Relay time).
01~98: Alarm if the door is not closed after the door open time and over the alarm delay time. (01~98s)
99: No Door O
p
en Alar
m
☞. This is the function to use GE314 as a Reader and sends 26bit Wiegand Output through two TTL output ports.
Press <ENT> key and select USE by pressing <4> or <6> key then press <ENT> key for setting.
UNUSE: Normal TTL outputs will be activated.
USE: 26bit Wiegand output will be generated through TTL1 and TTL2 port.
When an registered card is read, the “CARD SCCANNING OK” message will appear on the LCD.
z TTL1 : Data 0 TTL2 : Data 1
GE AccessSmart 314 Last Update July 6, 2005
42
9.4 F4 SETUP MENU
9.4.1 ID REGISTRATION
1. Registration by RF Card