User's Manual

ManualsBrandsUTC Fire & Security Americas ManualsElectronicsFingerprint Access Controller

GE AccessSmart 314 Last Update July 6, 2005

* Default Output Setting for Input Sources

9.6.1 EXIT BUTTON OUTPUT SETTING

9.6.2 DOOR CONTACT OUTPUT SETTING

9.6.3 AUX INPUT#1 OUTPUT SETTING

9.6.4 AUX INPUT#2 OUTPUT SETTING

9.6.5 TAMPER ALARM OUTPUT SETTING

9.6.6 DURESS ALARM OUTPUT SETTING

Output Time setting for above Input Sources are the same as 9.6.1 Exit Button Output setting.

OUTPUT

Door

Relay

(DR)

Alarm

Relay

(AR)

TTL#1

(T1)

TTL#2

(T2)

Buzzer

(BZ)

[1] EXIT BUTTON 03 00 00 00 00

[2] DOOR CONTACT 00 99 00 00 00

[3] AUX Input #1 00 00 00 00 00

[4] AUX Input #2 00 00 00 00 00

[5] TAMPER ALARM 00 99 99 99 99

[6] DURESS ALARM 00 00 00 00 00

[7] OUTPUT TIME SCHEDULE 00 00 00 00 00

[8] INPUT TIME SCHEDULE 00 00 00 00 00

. You can program ☞ OUTPUT activating time when the EXIT button pressed. The value put here is value x

second when the Time Unit set to 1 second and value/10 second when the Time Unit set to 0.1 sec.

You can set the time from 00 to 98 seconds (0.0 to 9.8 seconds if Time Unit set to 0.1 sec.) and if you put the

value “99”, the Output will activate forever until you reset the Output.

Press <4> or <6> key to select Input Sources then press <ENT> key to program the Output time.

DR: Door Relay Output

AR: Alarm Relay Output

T1: TTL#1 Output

T2: TTL#2 Output

BZ: Buzzer Output

GE AccessSmart 314 Last Update July 6, 2005

9.6.7 OUTPUT TIME SCHEDULE SETTING

9.6.8 INPUT TIME SCHEDULE SETTING

. You can ☞ link a T/S Code to each Output. The default T/S Code is “00” which means no T/S is applied to the

Outputs. This setting is very useful when you want to open the door for a Time Interval.

Press <ENT> key to link a T/S Code to the Output then enter 2digit T/S Code for each Output.

DR: Door Relay Output T/S Code

AR: Alarm Relay Output T/S Code

T1: TTL#1 Output T/S Code

T2: TTL#2 Output T/S Code

BZ: Buzzer Output T/S Code

. You can ☞ link a T/S Code to each Input. The default T/S Code is “00” which means no T/S is applied to the

Inputs. This setting is very useful when you want to activate PIR sensor input for a Time Interval.

Press <ENT> key to link a T/S Code to the Input then enter 2digit T/S Code for each Input.

EX: EXIT Button Input T/S Code

DC: Door Contact Sensor Input T/S Code

I1: Aux Input#1 T/S Code

I2: Aux Input#2 T/S Code

TP: Tamper Switch Input T/S Code