User's Manual

14. Click Save on the bottom of the screen.

Note: Do not hit Connect in the WPS Section.

15. Below the Key 1 box, verify that “Your Network” is now

showing connected.

16. Repeat steps for any additional cameras.

Note: Do not exit the TruVision Camera Configurator browser.

You are now connected to the network via Wi Fi!

Add Cameras to UltraSync

Ensure proper installation of camera hardware and adding cameras

to network before adding cameras to UltraSync.

Note: Make sure camera and UltraSync intrusion panel are on the

same local area network. Applications where the Intrusion panels

uses cellular only (no Wi Fi or Ethernet connection) are not

compatible with this camera.

Note: For detailed information on how to setup the UltraSync app,

add locations, and login as an installer, reference the intrusion

panel installation guide.

1. From your iOS or Android device, open the UltraSync App and

2. Click More on the bottom of the Screen, then Settings.

3. Select Cameras under Settings.

4. Select Scan for New Cameras.

5. “Success!” message will pop-up after a few moments.

Note: "Success" message appears after a camera scan was

executed. This does not indicate cameras were added to the

system.

6. The IP Address and MAC Address should automatically

populate for all cameras on the network. Scroll through cameras

using the camera selection list to verify connected cameras.

7. Click Save.

Note: Camera may take up to 1-2 minutes to finalize association

with intrusion panel and show in cameras tab.