User's Manual

Remove Camera from UltraSync (if needed)

1. Click the More tab on the bottom of the Screen.

2. Click Settings

3. Select Cameras under Settings Selector

4. Select the camera you with to remove.

5. Delete text in Camera Name, IP Address and MAC Address.

6. Click Save.

Note: To remove all cameras from UltraSync, go to Advanced

Settings and use SHORTCUT 910.22.

Reset Cameras to Factory Default (if needed)

If needed, the cameras can be reset to factory default.

Wedge Camera:

Remove the camera cover, remove power from camera, then press

and hold the RST/WPS button, apply power to camera and

continue holding RST/WPS button for 20 Seconds.

Desktop Camera:

1. Enter the Maintenance interface:

Configuration > Basic Configuration> System > Maintenance

Or Configuration > Advanced Configuration> System > Maintenance

2. Click Restore or Default to restore the default settings.

You can also use the RESET button on the desktop camera to

default the camera.

Note: After restoring the default settings, the IP address is also

restored to the default IP address.

RST/WPS