User's Manual

P/N 466-5236 • REV B • ISS 28APR16 © 2016 United Technologies Corporation. All rights reserved 27
Alternatives for Adding Cameras
via Wi Fi (using Windows PC for setup)
1. Power up the camera. (Boot up may take 1-2 minutes)
2. From your Windows PC, find and connect to your camera in the Wi Fi network list.
3. Go to Network and Sharing Center.
Control Panel > Network and Internet > Network and Sharing Center.
4. Click Change Adapter Settings on left.
5. Right click Wireless Network Connection and select Properties.
6. Click Internet Protocol Version 4 (TCP/IPv4) and click Properties.
7. Click “Use the following IP address”, enter the info below, and then click OK.
a) IP address: 192.168.2.71
b) Subnet mask: 255.255.255.0
8. Open Browser (Firefox, Chrome, IE8) and enter the camera’s IP Address into the
browser’s address bar.
a) Camera’s Default IP Address is 192.168.2.70.
9. TruVision Configurator will appear. Enter Credentials below.
a) User Name: admin
b) Password: 1-2-3-4
10. Click Configuration on the top menu.
11. Click Network on the left menu.
12. Click Wi Fi on the middle tab.
13. Select your network from the Wireless List.
14. Enter Wi Fi Network Passphrase in Key 1 Section.
15. Click Save on the bottom of the screen.
via Ethernet (non-DHCP, using iOS Device for setup)
1. Power up the camera. (Boot up may take 1-2 minutes)
2. From your iOS device, go to Settings, then Wi Fi.
3. Find and select your camera (Listed under Devices)
4. Once connected, hit the info circle on the right
5. Under IP Address, hit Static and enter the info below.
a) IP Address: 192.168.2.71
b) Subnet Mask: 255.255.255.0
6. Open Mobile Browser. (Safari)
7. Enter the camera’s default IP Address into the address bar.
a) 192.168.2.70
8. TruVision Configurator will appear. Enter Credentials below.
a) User Name: admin
b) Password: 1-2-3-4
9. Click Configuration on the top menu.
10. Click Network on the left menu.
11. Change LAN settings to desired configuration.
a) Change the IPv4 Address and IPv4 Subnet Mask to match the router if a
static IP Address is desired.
i. You must change the static IP address to something different than the
default 192.168.2.70 if more than one camera is used on the network.
ii. Make sure to use the Test button to validate IP Address is not already
assigned to another device in the network.
12. Click Save on the bottom of the screen.
13. Connect the camera via Ethernet to the network and power cycle the camera.