User's Manual

via Ethernet (non-DHCP, using Windows PC for setup)

1. Power up the camera. (Boot up may take 1-2 minutes)

2. From your Windows PC, find and connect to your camera in the Wi Fi network list.

3. Go to Network and Sharing Center.

Control Panel > Network and Internet > Network and Sharing Center.

4. Click Change Adapter Settings on left.

5. Right click Wireless Network Connection and select Properties.

6. Click Internet Protocol Version 4 (TCP/IPv4) and click Properties.

7. Click “Use the following IP address”, enter the info below, and then click OK.

a) IP address: 192.168.1.71

b) Subnet mask: 255.255.255.0

8. Open Browser (Firefox, Chrome, IE8) and enter the camera’s IP Address into the

browser’s address bar.

a) Camera’s Default IP Address is 192.168.1.70.

9. TruVision Configurator will appear. Enter Credentials below.

a) User Name: admin

b) Password: 1-2-3-4

10. Click Configuration on the top menu.

11. Click Network on the left menu.

12. Change LAN settings to desired configuration.

a) Change the IPv4 Address and IPv4 Subnet Mask to match the router if a

static IP Address is desired.

i. You must change the static IP address to something different than the

default 192.168.1.70 if more than one camera is used on the network.

ii. Make sure to use the Test button to validate IP Address is not already

assigned to another device in the network.

13. Click Save on the bottom of the screen.

14. Connect the camera via Ethernet to the network and power cycle the camera.