Installation guide

7. Connect the USB connector end of the Barcode Scanner cable to a USB port on the back of the

PC. Connect the other end into the jack on the barcode scanner handle.

Figure 5: Rear View of PC, Scanner connection

8. Connect the optional MSR (Magnetic Stripe Reader) assembly to the 1800 Series unit as follows:

Figure 6: Back View of 1800 Unit and MSR Assembly

1. Connect the USB cable

Insert the USB connector into the USB port at

the side of the main unit.

2. Position the MSR

Align the MSR unit with the guide rails on the

main unit and slide it into position, making

sure the entire USB cable is covered by the

MSR housing.

3. Insert and tighten screws

Insert the two screws provided with the MSR

unit, and tighten to secure the MSR housing

to the main unit.

Main Unit

USB Port

To MSR Unit

MSR Unit

Insert screws

USB