User manual

3BChapter 4: Configuring the camera
TruVision IP Dome Open-Standards User Manual 37
Click the Zone settings tab to display the motion detection screen.
Place your mouse pointer at a point on the screen from where you want to
start marking the motion detection area and it to mark the area sensitive to
motion. Several areas can be defined.
Note: You cannot adjust an area already drawn. Click Clear All to delete all
areas marked and restart drawing.
4. Select the motion detection sensitivity level from the drop-down list.
All areas will have the same sensitivity level.
5. Click the Linkage tab. The Linkage screen appears.
6. Check a response method for the system when a motion detection alarm is
triggered. You can check one or more of the following response methods:
Email link
Sends an e-mail to a specified address when there is a
motion detection alarm. See “Network parameters” on
page 23 for further information.
Trigger
alarm output Triggers the camera’s alarm output. Up to two alarm
outputs can be selected.
Trigger recording
Triggers the recording to start in the camera (A1).
7. Click Save to save changes.