User manual

TruVision DVR 60 User Manual 19
Chapter 3
Getting started
Turning on and off the DVR
Before turning the power on connect at least one monitor to the video out or the
VGA interface. Otherwise, you will not be able to see the user interface and
operate the device. Also connect at least one camera.
The TVR 60 auto-detects the video mode (PAL or NTSC) on startup.
The TVR 60 is equipped with a universal power supply that will auto-sense
110/240 V, 60/50 Hz.
Note: It is recommended that an uninterruptible power supply (UPS) is used in
conjunction with the device.
To turn on the DVR:
Turn on the DVR using the power switch on the rear panel. Once the TVR 60 is
powered up, the indicator bar on the front panel will light up green. All connected
cameras are displayed on-screen. The TVR 60 automatically begins recording.
To turn off the DVR:
Turn off the DVR using the power switch on the rear panel.
Using the Setup Wizard
The TVR 60 has an express installation wizard that lets you easily configure
basic DVR settings when first used. It configures all cameras simultaneously.
The configuration can then be customized as required.
By default the Setup Wizard will start once the DVR has loaded, as shown in
Figure 8 on page 20. The Setup Wizard will walk you through some of the more
important settings of your DVR.
Note: After the system is set up, you can uncheck the “Start wizard” box. The
setup wizard is then no longer started automatically.