Installation Guide

11
4
STEP Temporary installation of the back
wall
Quick tip 
Installing the walls temporarily will
ensure proper wall alignment before
permanent installation.
Make sure the wall is plumb and
centered on the base.
With a 1/8" bit, drill holes in the back wall fastening
flange (14) at the top aligned with each stud. Only pre-
drill the flange not the studs. Then, secure the back
wall (14) with one #8 x 1¾" screw (not included) in one
of the pre-drilled holes.
IMPORTANT: HAND TIGHTEN ONLY. TEMPORARY
INSTALLATION.
Quick tip 
Push the bottom of the back wall
with your foot when fastening in
place.
Plumbing the back wall is
critical for alignment of the
side wall
14
Cut view
Base threshold
Back wall
Position and level the back wall (14) by sitting it on the
threshold at the back of the base.
4.1
Check me!
4.2
Check me!
4.3
Check me!
Pull back the protective fi lm on the walls (14-15) at least
3" away from all edges. Keep the remaining protective
fi lm on the walls and base.
min.3/16"
max.3/8"
Stud
X fastener