Installation Guide

16
Check me!
Place the template in the corner of the shower where
you want to install your shelf.
Slide the template up until the points on the left and
right-hand side of the template are at the height you
want your shelf.
Use a pencil, marker or wax pencil to mark the spots
where the holes for the shelf will be drilled.
Drill the holes using a 9/64" drill bit.
8
STEP Marking and drilling the
glass shelf holes
Fold here
Drilling positions
90°
Quick tip 
Apply masking tape on both sides
of the joint where you will run a
bead of silicone. Apply the silicone,
smooth with a wet fi nger then
remove the masking tape.
Check me!
Apply a bead of silicone all along the wall to wall
and wall to base joints. For a smooth fi nish you can
remove the silicone excess with a damp rag or wet
fi nger.
9
STEP Silicone
All faucets installed on the walls
must be sealed with silicone.
Remove protective fi lm from walls