Installation Guide

DIRECT WIRE INSTALLATION

1. WARNING: Make sure the POWER is OFF.

If your fixture is to be direct wired, you will no longer need your

power cord and it should be discarded. Do NOT remove the

plastic receptacle cap that covers the input receptacle. Do

NOT plug your power cord into light fixture.

Using a Phillips head screwdriver, remove the screws on the

wire compartment cover (B) and lift up. Once the wire

compartment cover is free, remove it and set it aside.

4. Once the fixture (A) is secured to the cabinet, replace the wire

compartment cover (B). Plug in the power cord (C) and the

installation is complete.

INSTALLATION INSTRUCTIONS

Using a flathead screwdriver, or other similar tool, pry off the

plastic receptacle cap that covers the input receptacle on the

fixture in order to insert the power cord (C).

WARNING: DO NOT plug the power cord into the power supply

before finishing the installation. Attach the power cord (C) to the

“Power-In” receptacle on one end of the fixture (A). The 2

receptacles are designed to only accept a specific plug. NOTE:

The power cord (C) will only plug into one end correctly. Do not

try to force it into the wrong receptacle as this could cause

damage to the fixture. The power cord plug will be fully inserted

once the catch on the plug is engaged. Trace the line cord over

to the nearest outlet and plug in. Your light is ready to use.

PLUG-IN INSTRUCTIONS

3. KEYHOLE INSTALLATION: Position the fixture (A) and mark the

location of the narrow ends of the keyhole slots onto the mounting

surface. Drill a 1/16 in. pilot hole into the marked screw locations.

You can also use an awl or nail to dimple the screw holes. While

holding the fixture in place tighten the wood screws (AA) with a

phillips head screwdriver until the fixture is flush with the surface.

Hardware Used

Wood Screw x 2