Installation Guide

CAUTION
DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT. If you currently have dimmer
controls, you will need to remove them and replace them with regular electrical switches. If
you have a three-way dimmer, you will have to replace it with a regular three-way switch. If
you are unfamiliar with electrical installations, it is recommended you have a qualified
electrician do your installation.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Warning: Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
32
PACKAGE CONTENTS
PART DESCRIPTION QUANTITY
A Fixture 1
B Plastic End Cap 2
Lowes.com Lowes.com
SAFETY INFORMATION
•
•
SAFETY INFORMATION
Shut off power at the circuit breaker or fuse panel before removing the old fixture or
installing the new one.
•
WARNING
PREPARATION
Before beginning installation of product, make sure all parts are present. Compare parts
with package contents list and hardware contents list. If any part is missing or damaged,
do not attempt to assemble, install or operate the product.
Estimated Assembly Time: 30 minutes (two people required).
Tools Required for Assembly (not included): Phillips screwdriver, flathead screwdriver,
safety glasses, hammer, pencil, pliers, power drill and 1/8-in. drill bit or 5/32-in. drill bit.
HARDWARE CONTENTS
AA BB
B
A
B
CC
Wire Nuts
Qty. 3
Drywall Anchor
Qty. 4
Wood Screw
Qty. 4