Installation Guide
4 5
INSTALLATION INSTRUCTIONS
C
Lowes.com
Lowes.com
INSTALLATION INSTRUCTIONS
2. Support fixture pan (A) on mounting surface, aligning
lead wires at the back with the junction box (not
included).
Mark the mounting surface through the center points
of each of the four keyholes on the fixture pan (A).
Set fixture pan (A) aside.
2
3
4
4. With the assistance of another adult, hold fixture pan
(A) up toward junction box and connect the supply
wires to the fixture wires -- black to black, white to
white, and green to copper/bare. WARNING: If there
is no ground supply wire, stop installation and consult
a qualified electrician.
Once wire connections are made, secure each with a
wire nut (CC) and tuck all wiring into the junction box.
3. DRYWALL MOUNTING: If the mounting holes go
through drywall without a stud, drill four small pilot
holes using a 1/8-in. drill bit (not included), and install
drywall anchors (BB) into the holes with a hammer
(not included).
WALL STUD MOUNTING: If the mounting holes go
through wall studs, drill four small pilot holes using a
5/32-in. drill bit (not included) for the wood screws
(AA). NOTE: Do not install wood screws (AA) yet.
Hardware Used
Wire Nut x 3
CC
CC
A
A
A
Junction box location
behind xture pan
Mark these locations
on mounting surface
A
6
6. Carefully squeeze the diffuer (C) so one end will fit
into the end cap. Once the diffuser (C) is in place
carefully begin pushing down near the inserted end
and gradually move toward the other end until the
bottom lip of the diffuser (C) is fully engaged with the
fixture pan (A). Adjust the diffuser (C) by sliding it
between the end caps of the fixture pan (A) so any
gaps are covered.
7
7. OPTIONAL: To remove the pull chain extension (D),
simply push the end ball of pull chain (B) toward the
center of the coupling preassembed on the pull chain
extension (D) until it unlocks.
Wall Stud
Pilot hole
BB
Drywall Mounting Wall Stud Mounting
Drywall
Hardware Used
Drywall Anchor x 1
BB
5
5. Align fixture pan (A) keyholes to mounting holes and
secure fixture pan (A) to mounting surface with a
wood screw (AA) and washer (CC) for each keyhole.
Hardware Used
Wood Screw x 4
Washer x 4
AA
AA
CC
CC
Mounting Surface
B
B
D
D