Installation Guide

ManualsBrandsUtilitech Pro ManualsLED Under Cabinet LightsUC1051-AL3-22LF0-U

AA BB

PACKAGE CONTENTS

HARDWARE CONTENTS (shown actual size)

Qty. 2

Qty. 1

Wood

Screw

Strain Relief

A Fixture 1

PART DESCRIPTION QUANTITY

B Wire Compartment Cover 1

C Locking Tab 2

Power Cord

Linking Cord

This unit has a grounded plug as a safety feature. This plug will fit in a grounded outlet only one way.

If it still does not fit, contact a qualified electrician. Never use with an extension cord unless the plug

can be fully inserted. Do NOT attempt to override this feature.

WARNING

• Please read and understand this entire manual before attempting to assemble, operate

or install the product.

CAUTION

• This fixture is dimmable with a forward phase electronic dimmer. Dimmers tested to be

compatible with this fixture are the Lutron: Diva® C

•

L™: DVWCL-153P or DVCL-153P,

Lumea® C

•

L™: LGCL-153P, and Toggler® C

•

L™: TGCL-153P8. If unfamiliar with electrical

installations, it is recommended a qualified electrician do the installation.

• This device complies with Part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

WARNING: To reduce the risk of FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS:

1. For INDOOR USE ONLY.

2. Not intended for installation in plastic cabinets.

3. The mounting surface should be flat and sturdy enough to support the fixture.

4. Do NOT mount the fixture to cabinets having a material thickness less than 1/4 in.

5. Not intended for recessed installation in ceilings or soffits.

6. Do NOT use in wet locations.

7. Do NOT use for illumination of aquariums.

8. Do NOT mount over sinks or stoves.

9. Do NOT touch, operate, or install fixture while in contact with water.

10. Do not remove the protective LED lens or touch the LEDs at any time.

11. Use a soft cloth to clean the diffuser and/or fixture.

PLUG-IN/LINKING SAFETY INFORMATION:

12. Do NOT attempt to install while plugged in.

13. Use only insulated staples or plastic ties to secure the power or linking cords.

14. The National Electrical Code (NEC) does not permit cords to be concealed where damage to

insulation may go unnoticed. To prevent fire danger, do not run cord behind walls, ceilings, soffits,

cabinets, or similiar permanent structures where it may be inaccessible for examination. Cords

should be visually examined periodically and immediately replaced when any damage is noted.

15. Do not use an extension cord. Use power strip with integral overcurrent protection to supply

power to the fixture.

16. The total wattage of ALL the fixtures linked together in one chain should NOT exceed 360 watts.

Exceeding the total wattage will result in a hazardous situation. Fixture wattage can be found on

back of fixture.

IMPORTANT: These LED light heads use light emitting diodes to provide light. LEDs are electronic

semiconductors and do not have a filament that can burn out like an ordinary light bulb. As such, the

LED light heads can last up to 50,000 hours when used intermittently, and therefore, never need

replacing.

SAVE THESE INSTRUCTIONS IN A LOCATION CLOSE TO THE LIGHT FIXTURE TO REFER TO

THEM AT A LATER TIME. Before installation, plug in fixture to a 120 V, 60 Hz electrical outlet to check

for proper operation. Then, unplug and begin the installation.

IMPORTANT SAFETY INSTRUCTIONS

SAFETY INFORMATION

Lowes.com