Installation Guide

EXISTING CONSTRUCTION (JOIST/ ABOVE CEILING ACCESS APPLICATION) INSTALLATION
INSTRUCTIONS
1. Perform one of the following steps based on the
installation type:
a. If there is an existing fan in place, remove the
existing fan and ensure the opening in the
ceiling is large enough for the new fan.
b. If there is not an existing fan in place, choose
the location
in the ceiling and cut an opening
according
to the size of the template (I).
Ensure one edge
of the opening aligns with
the edge
of the joist.
2. Connect the round duckwork (not included) to
the duct adaptor (E) and secure with duct tape
(not included) or clamps (not included).
3. Connect the wiring according to the wiring
diagram.
a. Connect the black wire from the fan to the
black wire from the fan wall switch with two-port
quick connect (FF).
b. Connect the black wire from the light to the
black wire from the light switch with two-port
quick connect (FF).
c. Connect the white wire from the fan to the
white wire from the light and connect to the
line
in from the ceiling with three-port quick
connect (GG).
d. Connect the ground/green wire from the unit
to the ground bare wire
in the ceiling with two-
port quick connector (FF) .
e. Use the wire housing screw (EE) to screw the
wire housing cover (B).
Note: For single wall switch applications, remove
and cut the clear 2 port connectors from the
2 black wires coming from the bath
fan
chassis. Strip 1/2 in. of insulation from the
wire ends and connect both black wires to
the single black wire coming from the ceiling/
switch.
Hardware Used
• Wire Housing Screw X 1
10
(F uTILI TECH' )
Low es .com l:l -·-