Installation Guide
EXISTING CONSTRUCTION (BELOW CEILING APPLICATION) INSTALLATION INSTRUCTIONS
1.
Perform one
of
the following steps based on the
installation type:
a.
lfthere
is an existing fan
in
place, remove the
existing fan and ensure the opening
in
the ceiling is
large enough for the new fan. Use the template (I)
provided to determine
if
the existing hole
in
the
ceiling is large enough for this new fan to
be
installed. You may be required to make the hole
larger
to
match the size
of
the template (I)
provided.
Note: If the existing hole from the previous fan is
larger than the template
(1),
the hole must
be made smaller to match the template (I)
provided.
b.
lfthere
is not an existing fan
in
place, choose
the location
in
the ceiling and cut an opening
according to the size
of
the template (I).
Ensure one edge
of
the opening aligns with
the edge
of
the joist.
2.
Insert the housing (A) at an angle through
the ceiling opening and temporarily place the
housing (A) above the existing ceiling.
Note: For access from below installation, you must have at
least 8 inches
of
clearance between sub floor and
ceiling for the fan's chassis to fit properly.
13
r
[m UTIU
TECH"
)
L
owes
.
co
m
~
-~-