Installation Guide

NEW CONSTRUCTION INSTALLATION INSTRUCTIONS
10. Install the previously removed wire housing cover (J)
into the housing (A) and secure using the wire housing
screw (FF). Ensure all
of the wiring connections are
inside
of the housing (A) or under the wire housing
cover (J).
Hardware Used
• Wire Housing Screw ~
X 1
11. Connect the round ductwork (not included) to the duct
adaptor (D) and secure with duct tape (not included) or
clamps (not included). Then attach the duct adaptor
(D)
to the housing (A) by inserting the hooks of the duct t--..."'""1'("
adaptor (D) into the slots on the housing (A), and using
the duct adaptor screw (II), tighten the duct adaptor
screw (II) securely.
Hardware Used
0 Duct Adaptor Screw ()II
X 1
Proceed to FINAL INSTALLATION INSTRUCTIONS on
page 18.
EXISTING CONSTRUCTION (JOIST/ABOVE CEILING ACCESS APPLICATION) INSTALLATION
INSTRUCTIONS
1. Perform one of the following steps based on the
installation type:
a. If there is an existing fan
in place, remove the existing
fan and ensure the opening
in the ceiling is large joist
enough for the new fan.
b. If there is not an existing fan in place, choose the
location from above the ceiling and cut an opening
according to the size
of the template (G). Ensure one
edge
of the opening aligns with the edge of the joist.
10
~ UTILI TECH" J
Lowes .com \:1 -·-