Installation Guide
NEW CONSTRUCTION INSTALLATION INSTRUCTIONS
7.
Insert the existing wires from the installation location
through the punch-out hole on the housing (A).
8. Connect the wiring according to the wiring diagram.
a.
Connect the black wire from the fan
to
the black wire from
the fan switch with two-port quick connect (GG).
b.
Connect the black wire from the light
to
the black wire from
the light switch with two-port quick connect (GG).
c.
Connect the white wire from the fan to the white wire from
the light and connect to the line
in
from the ceiling with
three-port quick connect
(H
H).
d. Connect the ground/green wire from the unit to the ground
wire in the ceiling with two-port quick connect (GG).
Note: For single wall switch applications, remove and cut
the clear 2 port connectors from the 2 black wires
coming from the bath fan chassis. Strip 1/2 in.
of
insulation from the wire ends and connect both black
wires to the single black wire coming from the ceiling/
switch.
9. Strip 1/2
in.
of
insulation from wire ends. Grip the wire
firmly and push the stripped end
of
the wire into the open
port
of
two-port quick connect (GG) or three-port quick
connect (HH). Use only one stripped end
of
the wire per
port. Verify the stripped end
of
the wire is fully inserted to
the back
of
two-port quick connect (GG) or three-port
quick connect (HH).
Hardware Used
~
Two-port Quick Connect
~
4JD
Three-port Quick
Connect~
9
x3
X 1
Light
Sw
itch
Fan
Sw
1t
ch
BLK
Line
VYHT
In
GRD
- s lack
Switch B
ox
~
\'\tl
i
te
= G
re
e
nl
(bare)
Fan
house
wires
~
UTILI
TECH'
]
L
o
w
es
.
co
m
~
-ยท-: