Installation Guide
EXISTING CONSTRUCTION (JOIST/ABOVE CEILING ACCESS APPLICATION) INSTALLATION
INSTRUCTIONS
10. Install the previously removed wire housing cover (K)
into the housing (A) and secure using the wire housing
screw (II). Ensure all
of
the wiring connections are
inside
of
the housing (A) or under the wire housing
cover (K).
Hardware Used
0 Wire Housing Screw
~
X 1
Proceed to FINAL INSTALLATION INSTRUCTIONS on
page 16.
EXISTING CONSTRUCTION (BELOW CEILING APPLICATION) INSTALLATION INSTRUCTIONS
1.
Perform one
of
the following steps based
on
the
installation type:
a.
If there is an existing fan in place, remove the existing
fan
and ensure that the opening
in
the ceiling is large
enough for the new fan. Use the template (H) provided
to determine
if
the existing hole in the ceiling is large
enough for this new fan to be installed.
You
may
be
required
to
make the hole larger to match the size
of
the template (H) provided.
Note: If the existing hole from the previous fan is larger
than the template (H), the hole must
be
made
smaller
to
match the template (H) provided.
b.
lfthere
is not
an
existing fan
in
place, choose the
location
in
the ceiling and cut an opening according
to the size
of
the template (H). Ensure that one edge
of
the opening aligns with the edge
of
the joist.
2. Insert the housing (A) at an angle through the ceiling
opening and temporarily place the housing (A) above
the existing ceiling.
Note: For access from below installation, you must have
at least 10
in.
of
clearance between sub floor and
ceiling for the fan's chassis
to
fit properly.
13
joist
~
.
·
·
~
···--·-··-::
...
~
UTILI
TECH'
]
Lowes.com
l!l)
-·-: