Installation Guide
EXISTING CONSTRUCTION (BELOW CEILING APPLICATION) INSTALLATION INSTRUCTIONS
6.
Place two clips (BB) along
the
bottom
of
each side
of
the
housing (A) to hold the housing (A) in place.
Mount
the
housing (A) to
the
joist.
Note: The clips (BB) will ensure
the
bottom edge
of
the
housing (A) is flush with the ceiling board.
Hardware Used
eclip~
x4
7. Use long
screws
(AA) to
screw
the housing directly into
the
joist
through
the
holes
on
either
side
of
the housing
(A).
One
side
of
the
housing
has
four
holes
and
the
other
side
of
the housing
has
three holes. Choose a side
that
works
best
for
the
installation area.
Note: The bottom edge
of
the
housing (A)
must
be flush
with the finished ceiling.
Hardware Used
• Long
Screw
ij})ll)l)))))j)))))))))))))))jD>
x 3
or
4
8. Connect the wiring according to the wiring diagram.
a.
Connect the black wire from the fan
to
the black wire from
the fan switch with two-port quick connect (GG).
b.
Connect the black wire from the light
to
the black wire from
the light switch with two-port quick connect (GG).
c.
Connect the white wire from the fan to the white wire from
the light and connect to the line
in
from the ceiling with
three-port quick connect
(H
H).
d.
Connect the the red wire from the light to the red wire from
the nightlight switch with two-port quick connect (GG).
e.
Connect the ground/green wire from the unit to the ground
bare wire in the ceiling with two-port quick connect (GG).
Note: For single wall switch applications, remove and cut
the clear 2 port connectors from the 2 black wires coming
from the bath fan chassis. Strip 1/2
in.
of
insulation from the
wire ends and connect both black wires to the single black
wire coming from the ceiling/switch.
To
use the red wire/
nightlight, an additional switch will be needed.
15
4 holes
~
UTILI
TECH'
]
Low
es.com
l!l)
-·-: