Manualshelf

Installation Guide

ManualsBrandsUtilitech ManualsBath1.5-Sone 100-CFM Brushed Nickel Bathroom Fan with Light
11121314151617181920
EXISTING CONSTRUCTION (BELOW CEILING APPLICATION) INSTALLATION INSTRUCTIONS
9. Strip 1/2
in.
of
insulation from wire ends. Grip the wire
firmly and push the stripped end
of
the wire into the
open port
of
two-port quick connect (GG) or three-port
quick connect (HH). Use only one stripped end
of
the
wire per port. Verify the stripped end
of
the wire is fully
inserted to the back
of
two-port quick connect (GG) or
three-port quick connect (HH).
Hardware Used
G Two-port Quick Connect
~
x4
4JD
Three-port Quick
Connect~
X 1
10. Install the previously removed wire housing cover (K)
into the housing (A) and secure using the wire housing
screw (II). Ensure all
of
the wiring connections are
inside
of
the housing (A) or under the wire housing
cover (K).
Hardware Used
0 Wire Housing Screw
~
Proceed to FINAL INSTALLATION INSTRUCTIONS
below.
FINAL INSTALLATION INSTRUCTIONS
X 1
1. Install the motor assembly (B) into the housing (A) by
putting the preassembled flange on the motor assembly
(B) into the slide guide on the housing (A).
Important: Hold the motor
in
place to prevent
it
from
falling out.
16
house
wires
~
UTILI
TECH'
J
Lowes .com
~
-ยท-