Installation Guide

5
Lowes.com
ASSEMBLY INSTRUCTIONS
arm hole found on the sump pump A . Slide the
upper rubber grommet ( 1) removed in step 1 over
the end of the float assembly to secure the assembly
Remove the upper rubber grommet (1) from the
float assembly (B).
( )
Insert the top of the float assembly (B) into the switch
Install the bracket (2) on the float assembly (B) to
the hole on the column of the sump pump (A),
Adjust the position of the lower rubber grommet (3)
Adjust the position of the upper rubber grommet (1)
1
2
3
in place.
ensuring that the pin
the hole on the column.
on the bracket is inserted into
as necessary. The lower rubber grommet should be
between 5.5 in. and 9 in. from the top of the rod of
the float assembly.
as necessary. The upper rubber grommet should be
2 in. from the top of the rod of
the float assembly.
2.
1.
3.
1
B
A
1
B
1
B
3
2
A