Operating Guide

LOCATION

1. Pump (A) should be located within 15 ft. of the water

source, and strainer (C) should be used at the end of

the inlet line.

NOTE: Make sure the inlet hose is NOT coiled or

kinked above or below water level.

The inlet line may be galvanized pipe, plastic pipe, or

reinforced hose. Be sure there are no leaks in the inlet

line, as this may reduce pump efciency or prevent

priming. Inlet line should be the same diameter as the

discharge line, or larger.

DO NOT use regular garden hose on the inlet line as

it will collapse during pumping.

Standard 3/4 in. garden hose may be used as a

discharge line. Keep the total length as short as

possible for best performance.

15 Ft.

Maximum Distance

to Water Source

INSTALLATION INSTRUCTIONS

Reinforced

hose

1. Attach hose adapters (B) and suction hose

(not provided) to pump. Make sure inlet connection

is air tight.

NOTE: Regular garden hose should not be used on

pump (A) inlet. It will collapse when the pump runs.