Operating Guide

4
PREPARATION
CAUTION
Before beginning installation of product, make sure all parts are present. Compare parts with
package contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Installation Time: 10 minutes
Tools may be required for assembly: Crescent wrench, PVC-safe pipe sealant or thread sealant tape.
• PERSONAL INJURY OR PRODUCT DAMAGE MAY RESULT.
This pump operates on 115 volts. Make certain that the power source conforms to the
requirements of your equipment.
• PRODUCT DAMAGE MAY RESULT.
The maximum temperature of the pumped liquid must not exceed 120°F (40°C). The minimum
allowable temperature is 40°F (4°C).
• PRODUCT DAMAGE MAY RESULT.
Be sure the water source and piping are clear of sand, dirt, and scale. Debris will clog the pump
and void the warranty. Use a screen or strainer on the inlet to prevent debris from entering the
pump.
• PRODUCT DAMAGE MAY RESULT.
Failure to protect the pump and piping from freezing will cause damage and void the warranty.
• PRODUCT DAMAGE MAY RESULT.
Do not run pump dry. Impeller and seal damage will result.
• PROPERTY DAMAGE MAY RESULT.
Drain all liquids from the system before servicing or storing.
• PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY RESULT.
Make sure the discharge hose is secure before starting the pump. A loose discharge hose can
whip around and cause personal injury or property damage.
• PROPERTY DAMAGE MAY RESULT.
Do not operate this product while unattended.
• PROPERTY DAMAGE MAY RESULT.
Check hoses for worn areas before use and make certain that all connections are tight.
• PRODUCT DAMAGE MAY RESULT.
This pump is designed to pump water only. It has not been evaluated for pumping chemicals.
Check hoses for worn areas before use and make certain that all connections are tight.
• PRODUCT DAMAGE MAY RESULT.
Inspect the pump regularly for damage and perform routine maintenance as needed.