Operating Guide

GENERAL PUMP INFORMATION

This pump is designed to sprinkle lawns and small gardens from lakes, ponds, or rivers, empty or

ll stock tanks, remove standing water from ooded areas, transfer water or boost water pressure.

Flammable liquids such as gasoline, chemicals, or corrosive liquids should never be used with this

pump.

The pump is NOT designed to operate underwater.

SETUP

1. Before installing pump (A), have the electrical circuit checked by an electrician to ensure proper

grounding.

BE CERTAIN the pump (A) power source is disconnected before installing or servicing this unit.

Be sure the water source and piping are clear of sand, dirt, and scale. Debris will clog pump (A)

and void warranty.

Failure to protect pump (A) and piping from freezing could cause severe damage and will void the

warranty.

Do not run pump (A) dry.

INSTALLATION INSTRUCTIONS

PUMPING FROM LAKES, PONDS, OR SMALL

STREAMS

1. Set pump (A) as close as possible to the water

source, keeping the vertical distance from

the water to pump as short as possible and

no more than 20 ft. Place pump (A) on level

support. Protect against ooding and excessive

moisture.

Long lengths of pipe or hose and use of many

ttings will reduce the amount of water this unit

will pump. Use the smallest number of ttings

and shortest possible length of pipe or hose.

Water source

Outlet

Inlet

Maximum

20 ft.

vertical

distance