How to Guide

22 in.

18 in.

1-1/2-in discharge

pipe

Check valve

3/16-in

Vent hole

GFCI outlet

Basin cover

Fill with

water

1. Place pump (A) in a sump basin that is at

least 18 in. wide and 22 in. deep.

2. Install rigid 1-1/2 in. discharge pipe, union,

check valve according to code.

3. Drill a 3/16 in. hole in the discharge pipe, level

with the top of pump (A). Connect remaining

discharge pipe into main discharge line.

4. Connect pump (A) power supply to a

GFCI-protected receptacle.

5. Fill the basin with water to check operation.

Install a basin cover and gasket on top of

the basin.

SW1128 B

QUICK START GUIDE.

SEE INSTRUCTION

MANUAL FOR

COMPLETE DETAILS.

WARNING:

FOR YOUR PROTECTION, ALWAYS DISCONNECT

PUMP FROM POWER SOURCE BEFORE HANDLING.

ITEM #0955622, 0955624

SUBMERSIBLE

SUMP PUMP

MODEL #

148010, 148011

Printed in China

PAGE 1
ITEM #0955622, 0955624 SUBMERSIBLE SUMP PUMP A MODEL #148010, 148011 QUICK START GUIDE. SEE INSTRUCTION MANUAL FOR COMPLETE DETAILS. WARNING: FOR YOUR PROTECTION, ALWAYS DISCONNECT PUMP FROM POWER SOURCE BEFORE HANDLING. 22 in. 18 in. 1. P lace pump (A) in a sump basin that is at least 18 in. wide and 22 in. deep. 1-1/2-in discharge pipe Check valve A 3/16-in Vent hole 2. Install rigid 1-1/2 in. discharge pipe, union, check valve according to code. 3. D rill a 3/16 in.
PAGE 2
ARTÍCULO #0955622, 0955624 BOMBA DE SUMIDERO SUMERGIBLE A MODELO #148010, 148011 GUÍA DE INICIO RÁPIDO CONSULTE LOS DETALLES COMPLETOS EN EL MANUAL DE INSTRUCCIONES ADVERTENCIA: PARA SU PROTECCIÓN, DESCONECTE SIEMPRE LA BOMBA DE LA FUENTE DE SUMINISTRO ELÉCTRICO ANTES DE MANIPULARLA. 55,88 cm 45,72 cm 1. C oloque la bomba (A) en un contenedor para agua de sumidero de al menos 45.72 cm (18 pulg.) de ancho por 55.9 cm (22 pulg.) de profundidad. Tubo de descarga rígido de 1-1/2 pulg.