Warranty Guide

5. Make sure wire connections are secure. Carefully place wires

into junction box. Position the fixture (A) cover plate over the

crossbar.

Note: Put the long mounting screw removed in Step 2 through

the center hole and into the crossbar and tighten the screw until

secure. Insert mounting screw cap (DD) into mounting screw

hole. DO NOT overtighten.

IMPORTANT:

If wall mounted, make sure the fixture is mounted with the

sensor below the lamp heads.

If eave mounted, rotate the sensor 180° so the controls face the

ground.

6. After mounting the fixture, apply silicone caulking compound

completely around the perimeter of the cover plate where the back of

the cover plate meets the mounting surface. Silicone caulking

prevents water from seeping into the junction box.

Hardware Used

Mounting screw cap x 1