Use and Care Guide

11
Step 5: Carefully remove tape and label wires according to wiring diagram (see Fig 8).
Step 7: Remove the two screws (SH) holding lamp socket (SC) to (SA).
Step 10: Connect new ballast assembly by reversing steps 1 through 9.
Step 8: Remove the screw (SF) holding ignitor (SB) to ballast assembly.
Step 6: Remove wire nuts (SG) and save for new ballast installation.
Step 9: Remove the screw (SF) and capacitor (SI) to ballast assembly.
120 volts alternating current, 60 hertz.
Input
Fig. 8
Lowes.com
Ballast
SA
SG
SG
SG
SG
SG
SB
SI
AB
SC
Ignitor
Blue
Blue
Red
Red
Lamp
Socket
Red
Black
Black
White
White
White
White
White
White
Black
Red
Photocell
Socket
Capacitor