Installation Guide

11
EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS
10. Plug in LED panel (C) into the fan housing (A).
10
A
C
11. Secure the LED panel (C) to the fan housing (A) using
4 short machine screws (BB) and metal washers (DD).
Hardware Used
BB
Short machine screw
x 4
DD
Metal washer
x 4
11
A
C
BB
DD
12. Choose which rim (D) nish suits your room. Lay glass
globe (E) into chosen rim (D).
12
D
E
13. Line up the three notches around the outside of the LED
panel (C) with the three clips on the rim (D). Gently push
up the rim (D) and glass globe (E) as far as possible until
it stops.
13
C
E
D
Notch
Clip
Clip
Clip
Notch
Notch
14. Rotate the rim (D) until it hits the stop and cannot be
rotated any further. Slowly pull hands away and glass
globe (E) and rim (D) will be attached to the fan housing
(A).
14
E
A
D