Operating Guide

2
OPERATING INSTRUCTIONS
ASSEMBLY
1. Unpack the packing box and pull the fan out.
2. Place the fan upside down and rotate the feet
90 degrees counterclockwise so the feet are
perpendicular to the fan body. This will stabilize
the fan for use. (See Fig. 1)
3. Flip the fan right side up for use. (See Fig. 2)
1. Plug the fan into any standard household outlet.
2. The Speed Control Knob will turn the fan on and off
and also allow you to rotate between speeds.
3. Speeds - Position: 1-low 2-medium 3-high 0-off
USER SERVICING INSTRUCTIONS
a) Grasp plug and remove from the receptacle or other
outlet device.Do not unplug by pulling on cord.
b) Open fuse cover. Slide open fuse access cover on
top of attachment plug towards blades.
c) Remove fuse carefully. Push the fuse from the other
side or turn fuseholder over to remove fuse.
d) Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse.
e) Close fuse cover. Slide closed the fuse access cover on top of attachment plug.
f) Risk of fire. Do not replace attachment plug. Contains a safety device (fuse)
that should not be removed. Discard product if the attachment plug is damaged.
Notice:
1. When you replace fuse, please don’t operate suddenly or overexert, or else the
product will be damage or cause accident.
2. When you feel it hard to be operated, please make sure you have got the right
way.
CLEANING
1. Be sure to unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with mild soap and damp cloth or sponge.
Thoroughly remove soap film with clean water.
3. Be sure not to submerge in water or other liquids.
4. Avoid getting water or other liquids inside the motor housing.