Installation Guide

SAFETY INFORMATION

• To reduce the risk of fire and electric shock, use only the power supply adapter provided with the

fixture.

• DO NOT use an extension cord.

• To reduce the risk of burns, fire, electric shock or injury to persons, unplug from outlet before

attaching or removing parts.

• To reduce the risk of burns, fire, electric shock or injury to persons, DO NOT use the fixture if power

supply cord is frayed or broken or plug is damaged, if the fixture is not working properly, if it has

been dropped or damaged, or it has been submerged in water.

• To reduce the risk of burns, fire, electric shock or injury to persons, use this fixture ONLY for its

intended use as described in these instructions. DO NOT use attachments not recommended by the

manufacturer.

• To reduce the risk of burns, fire, electric shock or injury to persons, DO NOT mount or place near

gas or electric heaters, fireplaces, candles or other similar sources of heat.

• This is an electrical product, NOT a toy! To avoid the risk of fire, burns, personal injury or electric

shock, this product should not be played with or placed where small children can reach it.

• DO NOT use staples or nails to secure fixture; DO NOT place power cord on sharp hooks or nails.

• DO NOT place the fixture on products plugged into receptacles or luminaires.

• DO NOT plug in or operate the fixture when it is tightly coiled.

• DO NOT route the fixture through walls, doors, windows, or any similar part of the building structure.

• DO NOT install the fixture near flammable liquids.

WARNING

CAUTION

• ELECTRICAL PRODUCT. Keep away from children. Not recommended for children under the age

of six (6).

• TURN OFF ELECTRICITY at main fuse box (or circuit breaker box) before beginning installation by

removing the fuse (or switching the circuit breaker off).

• DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT. If you presently have dimmer controls,

you will need to remove them and replace them with regular electrical switches. If you have a

three-way dimmer, you will have to replace it with a regular three-way switch. If you are unfamiliar

with electrical installations, it is recommended you have a qualified electrician install your fixture.

• As a safety precaution, unplug power cord when not in use.

• DO NOT close doors and/or windows on the fixture or power cord as doing so may damage the

insulation wire(s).

• Total wattage for this fixture is 96 watts; do not overload. Connect end-to-end a maximum of six (6)

rope lights.

• This fixture should be used for decorative purposes only.

• To replace power cord, contact customer service or manufacturer.

• Replace fuse only with 5-amp, 125-volt fuse.