Instructions Manual

ELECTRICAL HOOKUP AT THE PUMP

Submersible Cable Splicing

Pump is equipped with a lead wire assembly. The length of wire needed to attach to this lead wire

assembly is equal to the distance from the pump in the well to the top of the well. Additional wire

will be needed to run from the top of the well to the house.

CAUTION: Follow instructions carefully to make a watertight splice. A leak in the splice can result

in pump damage, blown fuses, overload protector tripping or electric shock hazard.

Shrink tube

Metal Connector

Splicing instructions

1. Slide one black shrink tube from a heat

shrink splice kit (sold separately) over each

wire (including the green ground wire)

coming out of the pump. (Fig 1)

2. NOTE: For each wire coming out of the

pump , including the green ground wire,

slide the wire from the pump into one end

of a metal connector from the splicing

kit. Then slide stripped end of wire from

electrical cable into other end of metal

connector. Connector should be centered

over both wires. Squeeze metal connector

until it closes tightly over both wire ends.

(Fig 2)