Instructions Manual

For - 2-Wire Pumps - No Control Box Required.

WARNING: This equipment is intended for installation by a technically qualified electrician.

Failure to install it in compliance with national and local electrical codes may result in electrical shock

or fire hazard, unsatisfactory performance, and equipment failure.

WARNING: Always disconnect power source before working on or near the pump, its

connected load and wiring. If the power disconnect is out of sight, lock it in the open position and

tag to prevent unexpected application of power.

ELECTRICAL HOOKUP FROM THE HOUSE TO PUMP AND PRESSURE TANK

1. Determine proper voltage from breaker box

(sold separately) to pressure switch. (Fig. 1)

IL1170

2. Remove cover from pressure switch and

screw the switch into the 1/4 in. opening on

the top of the pipe tee. (Fig. 2)