Instructions Manual

3
Copyright © 2011 Star Water Systems. All rights reserved.
ELECTRICAL SHOCK HAZARD
Can shock, burn or cause death. Ground pump
before connecting to power supply.
ELECTRICAL SHOCK HAZARD
The pump is intended for use in a well. Motor
frame must be connected to power supply
ground or fatal electrical shock may result.
ELECTRICAL SHOCK HAZARD
NEVER leave fused disconnect switch or pressure
control switch cover or covers open (either
partially or completely) when not being worked
on by a qualified electrician or repairman.
WARNING
ELECTRICAL SHOCK ALERT
Follow all local electrical and safety codes, as
well as the National Electrical Code (NEC) and
the Occupational Safety and Health Act (OSHA).
ELECTRICAL SHOCK ALERT
All electrical wiring or service should be done by
a qualified electrician.
EXPLOSION ALERT
Do not use to pump flammable or explosive
fluids such as gasoline, fuel oil, kerosene, etc.
Do not use in flammable and/or explosive
atmospheres.
HAZARDOUS PRESSURE ALERT
Install pressure relief valve in discharge pipe.
Release all pressure on system before working on
any component.
CAUTION
ELECTRICAL SHOCK MAY OCCUR
Wire motor for correct voltage. See Electrical
section and motor nameplate.
ELECTRICAL SHOCK MAY OCCUR
Ground motor and controls before connecting to
power supply.
ELECTRICAL SHOCK MAY OCCUR
Follow wiring instructions in this manual when
connecting to power lines.
ELECTRICAL SHOCK MAY OCCUR
Protect power cable from nicks or cuts from
sharp objects or scraping on well casing when
lowering pump into well. Do not allow it to
come into contact with oil, grease, hot surfaces
or chemicals.
ELECTRICAL SHOCK MAY OCCUR
The motor voltage and phase indicated on the
motor nameplate should be checked against
the actual electrical supply. Check your power
source. Check electrical supply for correct
fusing, wire size, and adequate grounding and
transformer size.
PRODUCT DAMAGE MAY OCCUR
The power supply for a submersible pump
should be a separate circuit, independent of all
other circuits. It must be equipped with a fuse
box of ample capacity.
PRODUCT DAMAGE MAY OCCUR
Shut off power source when voltage drops 10%
below rated voltage of motor.
FIRE SAFETY
For fire protection, power supply should be free
of any building, preferably on a direct line from
transformer. In event of fire, wires will not be
destroyed and water supply not cut-off.
SAFETY INFORMATION
NOTE: Install all electrical equipment in protected area to provide adequate ventilation for pressure
switch and controls to prevent moisture damage to components.
NOTE: Install pump, pressure tank, pitless adaptor or well seal in accordance with state and local
plumbing codes.