Instructions Manual

9
Copyright © 2011 Star Water Systems. All rights reserved.
ASSEMBLY INSTRUCTIONS
Follow step 1a and 1b below for Schedule 80
pipe or step 2a and 2b for black poly pipe.
Schedule 80 pipe (recommended)
1a. Apply thread tape and then thread the
pipe directly into the pump discharge and
tighten. For 1 in. pipe, you will also need
a 1-1/4 in. x 1 in. reducer bushing, not
shown. (Fig. 1a)
Schedule
80 Pipe
Submersible
Pump
Torque
Arrestor
1a
1b
Black poly pipe
2a. Apply thread tape and thread a 1-1/4 in.
male barbed adaptor (sold separately) into
the top of the pump and tighten. If using
1 in. black poly pipe, install a 1-1/4 in. x
1 in. reducer bushing (sold separately) as
shown. (Fig. 2a)
IL1171
1-1/4 in.
male
barbed
adapter
1-1/4 in x
1 in.
reducer
bushing
2a
1b. Slide the two hose clamps packaged with
the torque arrestor (sold separately) over
the end of a short piece of Schedule 80
pipe (approximately 4 ft. long). The pump
will be easier to handle if a short piece is
installed first. Continue to Step 3.
(Fig. 1b)